3M MALAYSIA SDN BHD ======================================================================== CHEMICAL SAFETY DATA SHEET ======================================================================== Document id : 08-3432-5 Issue date : 15/08/2012 Version : 3.00 Supersedes date : 29/06/2006 Document status : Issued This CSDS has been prepared by Toxicology Department 3M Malaysia Sdn. Bhd. ------------------------------------------------------------------------ SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION ------------------------------------------------------------------------ Tradename 3M(TM) Fastbond(TM) Foam Adhesive 100 3M Product ID: 62-4284-6530-6, 62-4284-6535-5, 62-4284-7530-5, 62-4284-7536-2, 62-4284-8436-4, 62-4284-8530-4, 62-4284-8535-3, 62-4284-8536-1, 62-4284-9530-3, 62-4284-9535-2, 62-4284-9932-1, 62-4284-9939-6, 62-4284-5535-6, 62-4284-7535-4, 62-4284-9538-6 Intended Use of Product COMPANY IDENTIFICATION ---------------------- Manufacturer's name and address 3M 3M Center St. Paul, Minnesota 55144-1000 USA Importer's name and address 3M Malaysia Sdn. Bhd. Bangunan 3M No. 6, Persiaran Tropicana 47410 Petaling Jaya Selangor Telephone number 03-7806-2888 Emergency telephone number 1-651-7376501 ( 24 hours ) CONTACT POINT ------------- Designation Toxicology Coordinator Telephone number 03-7806-2888 ------------------------------------------------------------------------ SECTION 2: COMPOSITION/INFORMATION ON INGREDIENT ------------------------------------------------------------------------ Ingredient name CAS number Percentage ------------------------------------- ------------------ ------------- WATER 7732-18-5 50 - 60 POLYCHLOROPRENE 9010-98-4 40 - 50 ROSIN ACIDS 68512-67-4 1 - 5 Boric Acid 10043-35-3 0.1 - 1 Exposure Limits: 6 mg/m3 ACGIH: STEL; inhalable fraction 6 mg/m3 ACGIH: STEL; inhalable fraction; Category: Borates 6 mg/m3 ACGIH: STEL; inhalable fraction; Category: Boric acid (H3BO3) 2 mg/m3 ACGIH: TWA; inhalable fraction 2 mg/m3 ACGIH: TWA; inhalable fraction; Category: Borates 2 mg/m3 ACGIH: TWA; inhalable fraction; Category: Boric acid (H3BO3) ZINC OXIDE 1314-13-2 0.1 - 0.5 Exposure Limits: 10 mg/m3 ACGIH: STEL; respirable fraction 2 mg/m3 ACGIH: TWA; respirable fraction ------------------------------------------------------------------------ SECTION 3: PHYSICAL AND CHEMICAL PROPERTIES ------------------------------------------------------------------------ Physical form,Color,Odor Liquid rubber odor, thin liquid, white low viscosity liquid Water Solubility <<< Boiling point/boiling range = 100 C Melting point/melting range N/A Vapour pressure = 17.5 mmHg Percent Volatile 51 - 55 % by wt Evaporation rate = 1 Water=1 Vapour density = 1.1 Air=1 Specific gravity = 1.1 Water=1 Flash point N/A Autoflammability NOT DETERMINED Flammable Limits - LEL N/A Flammable Limits - UEL N/A Viscosity 15 - 40 centipoise ------------------------------------------------------------------------ SECTION 4: HAZARD IDENTIFICATION ------------------------------------------------------------------------ Risk Phrases Harmful to aquatic organisms. May cause long-term adverse effects in the aquatic environment. ------------------------------------------------------------------------ SECTION 5: FIRST AID MEASURES ------------------------------------------------------------------------ Instructions for Ingestion Do not induce vomiting unless instructed to do so by medical personnel. Give victim two glasses of water. Never give anything by mouth to an unconscious person. Get medical attention. Instructions for Eye Contact Flush eyes with large amounts of water. If signs/symptoms persist, get medical attention. Instructions for Skin Contact Wash affected area with soap and water. If signs/symptoms develop, get medical attention. Instructions for Inhalation Remove person to fresh air. If signs/symptoms develop, get medical attention. ------------------------------------------------------------------------ SECTION 6: FIRE FIGHTING MEASURES ------------------------------------------------------------------------ Suitable Extinguishing Media Fire Fighting Procedures Wear full protective equipment (Bunker Gear) and a self-contained breathing apparatus (SCBA). Special Instructions for Fire Fighting Not applicable. Exposure Hazards during Fire Material will not burn. ------------------------------------------------------------------------ SECTION 7: ACCIDENTAL RELEASE MEASURE ------------------------------------------------------------------------ Spill Response For larger spills, cover drains and build dikes to prevent entry into sewer systems or bodies of water. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Evacuate unprotected and untrained personnel from hazard area. The spill should be cleaned up by qualified personnel. Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapors, in accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and could cause flammable gases or vapors in the spill area to burn or explode. Contain spill. Collect as much of the spilled material as possible. Clean up residue with detergent and water. Place in a closed container approved for transportation by appropriate authorities. Dispose of collected material as soon as possible. Methods for Disposal Not applicable. ------------------------------------------------------------------------ SECTION 8: HANDLING AND STORAGE ------------------------------------------------------------------------ Storage Requirements Keep from freezing. Incompatible Materials Store away from oxidizing agents. Ventilation Keep container in well-ventilated area. Use Instructions Avoid contact with oxidizing agents. ------------------------------------------------------------------------ SECTION 9: EXP0SURE CONTROL AND PERSONAL PROTECTION ------------------------------------------------------------------------ Boric Acid (10043-35-3) Exposure Limits 6 mg/m3 ACGIH: STEL; inhalable fraction 6 mg/m3 ACGIH: STEL; inhalable fraction; Category: Borates 6 mg/m3 ACGIH: STEL; inhalable fraction; Category: Boric acid (H3BO3) 2 mg/m3 ACGIH: TWA; inhalable fraction 2 mg/m3 ACGIH: TWA; inhalable fraction; Category: Borates 2 mg/m3 ACGIH: TWA; inhalable fraction; Category: Boric acid (H3BO3) ZINC OXIDE (1314-13-2) Exposure Limits 10 mg/m3 ACGIH: STEL; respirable fraction 2 mg/m3 ACGIH: TWA; respirable fraction Recommended Ventilation Use with appropriate local exhaust ventilation. Provide appropriate local exhaust ventilation on open containers. Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits and/or control mist, vapor, or spray. If ventilation is not adequate, use respiratory protection equipment. Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits. If ventilation is not adequate, use respiratory protection equipment. Eye Protection Avoid eye contact. The following should be worn alone or in combination, as appropriate, to prevent eye contact: Safety glasses with side shields Hand Protection The following glove material(s) are recommended: butyl rubber neoprene nitrile rubber Polymer laminate polyvinyl alcohol Skin Protection Gloves not normally required. Avoid prolonged or repeated skin contact. Respiratory Protection Under normal use conditions, airborne exposures are not expected to be significant enough to require respiratory protection. Avoid breathing of vapors, mists or spray. Avoid breathing of airborne material. Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with regulations: Half facepiece or full facepiece air-purifying respirator suitable for particulates Half facepiece or full facepiece air-purifying respirator suitable for particulates Half facepiece or full facepiece air-purifying respirator suitable for particulates Ingestion Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Keep out of the reach of children. ------------------------------------------------------------------------ SECTION 10: STABILITY AND REACTIVITY ------------------------------------------------------------------------ Materials to Avoid Strong Oxidizing Agents Hazardous Decomposition Aldehydes During Combustion Hydrocarbons During Combustion Carbon monoxide During Combustion Carbon dioxide During Combustion Hydrogen Chloride During Combustion Irritant Vapors or Gases During Combustion Ketones During Combustion Stability and Reactivity Hazardous polymerization will not occur. Stable ------------------------------------------------------------------------ SECTION 11: TOXICOLOGICAL INFORMATION ------------------------------------------------------------------------ Effects from Eye Contact Mild Eye Irritation: Signs/symptoms may include redness, pain, and tearing. Effects from Skin Contact Mild Skin Irritation: Signs/symptoms may include localized redness, swelling, and itching. Effects from Inhalation Respiratory Tract Irritation: Signs/symptoms may include cough, sneezing, nasal discharge, headache, hoarseness, and nose and throat pain. Effects from Ingestion Gastrointestinal Irritation: Signs/symptoms may include abdominal pain, stomach upset, nausea, vomiting and diarrhea. Reproductive Effects Contains a chemical or chemicals which can cause birth defects or other reproductive harm. ------------------------------------------------------------------------ SECTION 12: ECOLOGICAL INFORMATION ------------------------------------------------------------------------ Environmental Data No data available. Ecotoxicity Data Not determined. Ecofate Data Not determined. ------------------------------------------------------------------------ SECTION 13: DISPOSAL INFORMATION ------------------------------------------------------------------------ Product as Sold Dispose of completely cured (or polymerized) wastes in a sanitary landfill. Incinerate in an industrial or commercial facility in the presence of a combustible material. As a disposal alternative, dispose of waste product in a facility permitted to accept chemical waste. Combustion products will include HCl. Facility must be capable of handling halogenated materials. ------------------------------------------------------------------------ SECTION 14: TRANSPORT INFORMATION ------------------------------------------------------------------------ UN Number NOT HAZARDOUS FOR TRANSPORT FOR DOT, IMO, OR IATA. IMO Class NOT HAZARDOUS FOR TRANSPORT FOR DOT, IMO, OR IATA. ICAO Class NOT HAZARDOUS FOR TRANSPORT FOR DOT, IMO, OR IATA. Special Instructions Transportation classifications are provided as a customer service. As for shipping, YOU remain responsible for complying with all applicable laws and regulations, including proper transportation classification and packaging. 3M's transportation classifications are based on product formulation, packaging, 3M policies and 3M's understanding of applicable current regulations. 3M does not guarantee the accuracy of this classification information. This information applies only to transportation classification and not the packaging, labeling or marking requirements. The above information is only for reference. If you are shipping by air or ocean, YOU are advised to check & meet applicable regulatory requirements. ------------------------------------------------------------------------ SECTION 15: REGULATORY INFORMATION ------------------------------------------------------------------------ Symbols None Risk Phrases Harmful to aquatic organisms. May cause long-term adverse effects in the aquatic environment. Safety Phrases Use only in well ventilated areas. Do not breathe vapor or spray. S24/25 Avoid contact with the skin and eyes. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. After contact with skin, wash immediately with plenty of soap and water. Avoid release to the environment. Refer to special instructions/safety data sheets. Special Regulatory Information Contact 3M for more information. ------------------------------------------------------------------------ SECTION 16: OTHER INFORMATION ------------------------------------------------------------------------ Reason for Reissue Added/Deleted stock numbers. The information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. Any use of the product which is not in conformance with this data sheet or which involves using the product in combination with any other product or any other process is the responsibility of the user.