3M MALAYSIA SDN BHD ======================================================================== CHEMICAL SAFETY DATA SHEET ======================================================================== Document id : 11-3491-5 Issue date : 23/05/2006 Version : 2.00 Supersedes date : 17/01/2005 Document status : Issued This CSDS has been prepared by Toxicology Department 3M Malaysia Sdn. Bhd. ------------------------------------------------------------------------ SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION ------------------------------------------------------------------------ Tradename 3M(TM) FINESSE-IT(TM) FINISHING MATERIAL PN 051144-81820 3M Product ID: 60-9800-0952-0 Intended Use of Product COMPANY IDENTIFICATION ---------------------- Manufacturer's name and address 3M 3M Center St. Paul, Minnesota 55144-1000 USA Importer's name and address 3M Malaysia Sdn. Bhd. Bangunan 3M No. 6, Persiaran Tropicana 47410 Petaling Jaya Selangor Telephone number 03-7806-2888 Emergency telephone number 1-651-7376501 ( 24 hours ) CONTACT POINT ------------- Designation Toxicology Coordinator Telephone number 03-7806-2888 ------------------------------------------------------------------------ SECTION 2: COMPOSITION/INFORMATION ON INGREDIENT ------------------------------------------------------------------------ Ingredient name CAS number Percentage ------------------------------------- ------------------ ------------- WATER 7732-18-5 40 - 70 HYDROTREATED HEAVY NAPHTHA 64742-48-9 10 - 30 (PETROLEUM) MEDIUM ALIPHATIC SOLVENT NAPHTHA 64742-88-7 10 - 30 WHITE MINERAL OIL (PETROLEUM) 8042-47-5 7 - 13 ALUMINUM OXIDE 1344-28-1 3 - 7 GLYCERIN 56-81-5 1 - 5 ETHYLENE GLYCOL MONORICINOLEATE 106-17-2 1 - 5 STODDARD SOLVENT 8052-41-3 0.1 - 1 ------------------------------------------------------------------------ SECTION 3: PHYSICAL AND CHEMICAL PROPERTIES ------------------------------------------------------------------------ Physical form,Color,Odor Liquid Little odor, white, creamy thick liquid Creamy thick liquid Water Solubility <<< Boiling point/boiling range = 100 C Melting point/melting range NOT DETERMINED Vapour pressure NOT DETERMINED Percent Volatile = 70 % Evaporation rate = 4.4 Ether=1 Vapour density = 1 Air=1 Specific gravity 0.96 - 0.99 Water=1 Flash point = 80 C TCC Autoflammability NOT DETERMINED Flammable Limits - LEL = 0.8 % Flammable Limits - UEL = 6 % Viscosity 7500 - 16500 centipoise ------------------------------------------------------------------------ SECTION 4: HAZARD IDENTIFICATION ------------------------------------------------------------------------ Risk Phrases Repeated exposure may cause skin dryness or cracking. Toxic to aquatic organisms. May cause long-term adverse effects in the aquatic environment. ------------------------------------------------------------------------ SECTION 5: FIRST AID MEASURES ------------------------------------------------------------------------ Instructions for Ingestion Do not induce vomiting unless instructed to do so by medical personnel. Give victim two glasses of water. Never give anything by mouth to an unconscious person. Get medical attention. Instructions for Eye Contact Flush eyes with large amounts of water. If signs/symptoms persist, get medical attention. Instructions for Skin Contact Wash affected area with soap and water. If signs/symptoms develop, get medical attention. Instructions for Inhalation Remove person to fresh air. If signs/symptoms develop, get medical attention. ------------------------------------------------------------------------ SECTION 6: FIRE FIGHTING MEASURES ------------------------------------------------------------------------ Suitable Extinguishing Media Use fire extinguishers with class B extinguishing agents (e.g., dry chemical, carbon dioxide). Fire Fighting Procedures Water may not effectively extinguish fire; however, it should be used to keep fire-exposed containers and surfaces cool and prevent explosive rupture. Wear full protective equipment (Bunker Gear) and a self-contained breathing apparatus (SCBA). Special Instructions for Fire Fighting Not applicable. Exposure Hazards during Fire Closed containers exposed to heat from fire may build pressure and explode. Vapors may travel long distances along the ground or floor to an ignition source and flash back. ------------------------------------------------------------------------ SECTION 7: ACCIDENTAL RELEASE MEASURE ------------------------------------------------------------------------ Spill Response For larger spills, cover drains and build dikes to prevent entry into sewer systems or bodies of water. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Evacuate unprotected and untrained personnel from hazard area. The spill should be cleaned up by qualified personnel. Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapors, in accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and could cause flammable gases or vapors in the spill area to burn or explode. Contain spill. Collect as much of the spilled material as possible using non-sparking tools. Clean up residue with detergent and water. Place in a closed container approved for transportation by appropriate authorities. Dispose of collected material as soon as possible. Methods for Disposal Not applicable. ------------------------------------------------------------------------ SECTION 8: HANDLING AND STORAGE ------------------------------------------------------------------------ Storage Requirements Keep from freezing. Incompatible Materials Store away from acids. Store away from heat. Store out of direct sunlight. Store away from oxidizing agents. Fire Prevention No smoking while handling this material. Explosion Prevention Keep away from heat, sparks, open flame, pilot lights and other sources of ignition. Combustible liquid and vapor. Use Instructions Keep container tightly closed. Avoid contact with oxidizing agents. ------------------------------------------------------------------------ SECTION 9: EXP0SURE CONTROL AND PERSONAL PROTECTION ------------------------------------------------------------------------ HYDROTREATED HEAVY NAPHTHA (PETROLEUM) (64742-48-9) Exposure Limits 100 ppm 3M: TWA 1900 mg/m3 CMRG: TWA 300 ppm CMRG: TWA MEDIUM ALIPHATIC SOLVENT NAPHTHA (64742-88-7) Exposure Limits 100 ppm CMRG: TWA WHITE MINERAL OIL (PETROLEUM) (8042-47-5) Exposure Limits 10 mg/m3 5 mg/m3 10 mg/m3 5 mg/m3 CMRG STEL 1991 CMRG TWA 1991 ACGIH STEL AS MIST 1985 Category: OIL MIST, MINERAL ACGIH TWA AS MIST 1985 Category: OIL MIST, MINERAL ALUMINUM OXIDE (1344-28-1) Exposure Limits 10 mg/m3 1 FIBER/CC ACGIH: TWA - specific form; as particulate; Table A4; per ACGIH 2003, for particulate matter ct no asbestos and <1% crystalline silica. CMRG: TWA; MAN-MADE MINERAL FIBERS GLYCERIN (56-81-5) Exposure Limits 10 mg/m3 ACGIH: TWA - as mist; Particulates not otherwise classified. STODDARD SOLVENT (8052-41-3) Exposure Limits 525 mg/m3 100 ppm ACGIH: TWA ACGIH: TWA Recommended Ventilation Use with appropriate local exhaust ventilation. If exhaust ventilation is not available, use appropriate respiratory protection. Eye Protection Avoid eye contact. Avoid eye contact with vapors, mists, or spray. The following should be worn alone or in combination, as appropriate, to prevent eye contact: Safety glasses with side shields Indirect Vented Goggles Hand Protection Not applicable. Gloves are not required. The following glove material(s) are recommended: neoprene nitrile rubber Skin Protection Avoid skin contact. Avoid prolonged or repeated skin contact. Respiratory Protection Avoid breathing of vapors, mists or spray. Avoid breathing of dust. Consult the current 3M Respirator Selection Guide for additional information or call 1-800-243-4630 for 3M technical assistance. Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with regulations: Half facepiece or fullface air-purifying respirator with P95 particulate filters Ingestion Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Not applicable. Keep out of the reach of children. ------------------------------------------------------------------------ SECTION 10: STABILITY AND REACTIVITY ------------------------------------------------------------------------ Materials to Avoid Strong Oxidizing Agents Hazardous Decomposition Carbon Monoxide Carbon Dioxide Stability and Reactivity Stable Hazardous polymerization will not occur. ------------------------------------------------------------------------ SECTION 11: TOXICOLOGICAL INFORMATION ------------------------------------------------------------------------ Effects from Eye Contact Mild Eye Irritation: Signs/symptoms may include redness, pain, and tearing. Effects from Skin Contact Mild Skin Irritation: Signs/symptoms may include localized redness, swelling, and itching. Effects from Inhalation May be absorbed following inhalation and cause target organ effects. Respiratory Tract Irritation: Signs/symptoms may include cough, sneezing, nasal discharge, headache, hoarseness, and nose and throat pain. Intentional concentration and inhalation may be harmful or fatal. Effects from Ingestion May be absorbed following ingestion and cause target organ effects. Gastrointestinal Irritation: Signs/symptoms may include abdominal pain, stomach upset, nausea, vomiting and diarrhea. Other Toxicological Information Central Nervous System (CNS) Depression: Signs/symptoms may include headache, dizziness, drowsiness, incoordination, nausea, slowed reaction time, slurred speech, giddiness, and unconsciousness. ------------------------------------------------------------------------ SECTION 12: ECOLOGICAL INFORMATION ------------------------------------------------------------------------ Environmental Data No data available. Ecotoxicity Data Not determined. Ecofate Data Not determined. ------------------------------------------------------------------------ SECTION 13: DISPOSAL INFORMATION ------------------------------------------------------------------------ Product as Sold Incinerate in an industrial or commercial facility. As a disposal alternative, dispose of waste product in a facility permitted to accept chemical waste. ------------------------------------------------------------------------ SECTION 14: TRANSPORT INFORMATION ------------------------------------------------------------------------ UN Number IMO Class ICAO Class Special Instructions ** NOT HAZARDOUS FOR TRANSPORT FOR DOT, IMO, OR IATA. ------------------------------------------------------------------------ SECTION 15: REGULATORY INFORMATION ------------------------------------------------------------------------ Symbols N Dangerous to environment Risk Phrases Repeated exposure may cause skin dryness or cracking. Toxic to aquatic organisms. May cause long-term adverse effects in the aquatic environment. Safety Phrases Use only in well ventilated areas. Do not breathe vapor. S24/25 Avoid contact with the skin and eyes. After contact with skin, wash immediately with plenty of soap and water. If swallowed, seek medical advice immediately and show this container or label. Avoid release to the environment. Refer to special instructions/safety data sheets. Keep out of the reach of children. Special Regulatory Information Contact 3M for more information. ------------------------------------------------------------------------ SECTION 16: OTHER INFORMATION ------------------------------------------------------------------------ Reason for Reissue The MSDS has been revised because 3M has adopted the 16-section ANSI/ISO format. The potential hazards of the product have not changed. We encourage you to reread the MSDS and review the information. The information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. Any use of the product which is not in conformance with this data sheet or which involves using the product in combination with any other product or any other process is the responsibility of the user.